Guide for Raspberry Pi Assembly

Guide on installation of Raspberry Pi and assembly of components.


In this guide, we will show a step by step assembly and installation of the Operating System for a Raspberry Pi 4 Model B (8gb Ram).

For this particular installation, we will need a Vilros kit which consists of the following pieces:

• One black aluminum case with a large cooling fan to cool down the unit.
• Power Supply of 5v- 3A (USB-C connection).
• A micro HDMI adaptor for normal HDMI screens.
• One Raspberry Pi 4 Model B (8GB ram).

We also must have a microSD card as the Raspberry units disk space. We will launch our OS from said microSD card. The Vilros kit does not include one.


The first thing we must do is very that the Raspberry Pi be in optimal conditions, without damage of any kind due to the shipment process or manufacturing issues that have recently become relevant. Verify that there is no SdCard of any kind, but as mentioned, the Vilros kit does not contain an SD card.

Raspberry Pi 8 model 8GB
Vilros Assembly Kit

At this point, we begin to assemble the Raspberry Pi CPU/Controller into the Vilros aluminum case.

Vilros Kit + Raspberry Pi

Once the case is securely attached to the Raspberry Pi, we need to also make sure that the heat dissipaters pictured below are ready.

Heat dissipaters placed on top of processors.
Heat Dissippaters placed on top of Raspberry Pi Processors.

Each processor will have a dissipater glued to a chip surface. This permits for performance enhancements due to cooler operating conditions.


Now we must connect the cooling fan to the upper part of the case. The kit comes with an image that explains which of the metal pins to connect your fan to along with where to place a cable to ground the electricity (presumably).

You’ll need to connect pin #1 to slot number 14.

The pin number assignment is literally at the bottom of the pins over the green surface of the board.